News

In medical X-ray diagnostic equipment, the part where the patient lies horizontally is called the “bed board”. The selection of the medical bed board must not only consider the load-bearing, but also the attenuation of X-ray rays. Traditional medical bed

The carbon fiber winding molding process can be divided into wet winding and dry winding. Wet winding is widely used due to its lower cost and better craftsmanship. Wet winding equipment mainly includes fiber frames, tension control equipment, and dipping

Medical care Independently develop and design various styles of carbon fiber wheelchair parts. Breast X-ray Inspection CF Plate Carbon fiber composite materials have excellent X-ray transmittance, with an X-ray transmittance of 99%. For equipment such as breast machines, which have

As a new synthetic material, carbon fiber is essentially an inorganic polymer fiber with a carbon content higher than 90%. The microstructure of carbon fiber is similar to artificial graphite, which is a turbostratic graphite structure. And carbon fiber, a

When carbon fiber products use the autoclave process, the methods and steps are similar. Basically, they follow the steps of laying up blank parts, making vacuum bags, vacuum leak detection, putting the workpiece into the tank and starting the temperature

Future started producing high-performance fabrics in 2016 and is committed to the research and development of various high-performance fabrics. It has the production capacity of woven fabrics and multi-axial fabrics. Product Features： ·Weavable carbon fiber tow range: 1K~50K ·Fabric density

Sheet molding compound is to place the sheet molding compound into a mold that has been heated to a specified temperature, pressurize it through a hydraulic press, so that the molten sheet molding compound evenly fills the mold cavity, and

The vacuum introduction process refers to laying “dry” reinforcement materials (glass fiber, carbon fiber, sandwich materials, etc., different from the vacuum bag process) on the mold, then laying the vacuum bag, and extracting the vacuum in the system to form

The characteristics of unidirectional woven fabric are as follows: 1. When undergoing bending reinforcement, the fiber direction should be consistent with the direction of the reinforcement; 2. When performing shear reinforcement or seismic reinforcement, the fiber direction should be perpendicular